A packing tape dispenser is a very useful and convenient aid for gift wrapping, box packaging and shipping jobs in offices. The sticky packaging tape dispenser acts as a tape holder and roller masking gadget making it extremely convenient to use the tape for every kind of packaging. Although it is pretty easy using this dispenser, it helps to know the exact method of putting it to best use and avoid wastages. More importantly, you should also remember initially it could be a bit tricky loading the tape into the dispenser. However, once you have succeeded in setting things up, the packaging tape dispenser will save you a significant amount of time, and therefore money. Further, when packages are not properly taped, you run the risk of the shipping company returning them to you. Most of us do want to avoid such a situation.
Let us now get straight to loading the scotch packing tape dispenser
Table of Contents
1.Locate where the tape roll ends.
Generally, the end is clearly marked if you are loading a new roll. But, when you need to work with used rolls, you can run your fingernail along with the tape and feel the end. Once the end is located, you can use your nails to peel off from the joinery and pull out about half an inch of tape and fold it back on the tape roll. This way you can simulate how the end looks like in a new tape. Since these tapes are pretty sticky having quick access to the end of the tape will save a lot of time and effort.
2.Sliding into the spindle
To slide the tape into the spindle place the packaging tape dispenser handle to your right with the non-adhesive part of the tape facing up. The end of the roll should face the cutting blade and the roller. If you have difficulty putting the tape roll on the spindle this way, you can lay down the dispenser on a stable and flat surface which will make it easier for you to load the tape.
3.Threading the tape
The next step is to thread the end of your tape roll between the guide and the roller. You will find a small slot between the plastic or metal guide and the dispenser roller. Holding open the guide by pressing it down using the tab right below will allow you adequate room to thread through the tape.
4.Pulling the tape up to go over the blade
The packaging tape dispenser has a serrated blade and you should pull the tape about 2 inches so that you are free from the risk of cutting your fingers on the blade. Now you can pull back the tape against the cutting edge of the blade to an even and neat cut.
5.Adjusting the tension of the packaging tape dispenser
Roll a small portion of the tape to check the tension of the dispenser. For this trial run, you can use an old box. Cut off about 5 inches of the tape using the serrated blade and check if the tape is unwinding smoothly and correctly sticking to the box. Take care not to test on packages that you have lined up to be moved out. Before starting working with actual packages ensure that the dispenser is loaded properly and adjusted.
6.Increasing tension
When you need to increase the tension you can simply find the nut on the dispenser spindle and turn it clockwise to tighten. With too little tension, the tape may fail to wrap tightly around packages and achieve proper sealing. Similarly, when the spindle is very loose, you may be using significantly more tape than is necessary.
7.Decreasing tension
At times, you may also need to decrease the tension. This can be easily achieved by simply turning the nut counterclockwise. When the spindle is extremely tight, smooth and even rolling of the tape over packages and adhesion to the packages the way it is intended to may be impacted. By maintaining correct tension through loosening or tightening of the nut you can ensure optimal results.
Conclusion
Using a packaging tape dispenser is no rocket science and we are sure this guide will make it even easier for you to get the best results from this small gadget
